Rubber Covered Filter Plate
For hot, abrasive or coarse slurries
Rubber-faced plates for elevated temperature and abrasive duties where plain PP wears quickly.
- Material
- Rubber covered steel or PP core
- Plate sizes
- 630 – 1500 mm
- Working pressure
- 0.6 – 1.6 MPa
- Working temperature
- Up to 100 °C
Typical configuration shown. Final specifications confirmed on the approved drawing.
Overview
Where this model fits
Rubber covered plates protect the plate face where slurries are hot, coarse or abrasive. The rubber layer absorbs impact from fast-filling chambers and limits wear at the feed eye. They are heavier than PP plates, so frame capacity and handling method should be checked before specifying.
Technical parameters
Swipe to see all specifications on mobile
| Parameter | Typical configuration |
|---|---|
| Material | Rubber covered steel or PP core |
| Plate sizes | 630 – 1500 mm |
| Working pressure | 0.6 – 1.6 MPa |
| Working temperature | Up to 100 °C |
| Feed port | Centre feed with wear insert |
| Cake thickness | 25 – 40 mm |
| Handling | Crane or plate shifter recommended |
Cycle, step by step
- 01
Survey
Frame, rail and closing pressure are checked before fitting.
- 02
Fit
Plates are set with the rubber face toward the cake.
- 03
Feed
Fill rate is controlled to limit impact at the feed eye.
- 04
Filter
The rubber face protects the core through the cycle.
- 05
Inspect
Wear at the eye and sealing edge is checked at intervals.
Options and configuration
- Replaceable feed eye insert
- High-temperature cloth matching
- Reinforced handles
- Stack survey before replacement
Applied in these industries
Quote request
Get a quotation for the Rubber Covered Filter Plate
The product is pre-filled in the form. Add slurry conditions, flow rate and the target cake moisture so the quotation is based on your duty, not a generic model.
We usually reply within one business day.
Related models
All filter plates
PP Chamber Filter Plate
Moulded PP plates in standard sizes, with centre or corner feed and a range of handle options.
- MaterialPolypropylene (PP)
- Plate sizes630, 800, 1000, 1250, 1500, 2000 mm
- Plate thickness50 – 90 mm by size
Membrane Filter Plate
A PP carrier with a flexible membrane face, for presses that need a squeeze stage and drier cake.
- MaterialPP carrier with elastomer membrane
- Plate sizes800 – 2000 mm
- Membrane pressure1.0 – 2.5 MPa
BC-MP Membrane Filter Press
Chamber filtration followed by a membrane squeeze stage, for fine and compressible solids where cake moisture matters.
- Filtration area80 – 1000 m² (typical range)
- Plate size800 – 2000 mm
- Chamber count20 – 100